Mercedes CLA Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I've had a read through a few posts on here with a similar question. I need to change my brake disk and pads, i know where the jacking points are but wanted to put axle stands under the car just in case something happens to the jack, where is best to place them?
 

·
Registered
Joined
·
11,133 Posts
Just behind the front wheels, just ahead of the rear wheels, look for a plastic “port”
If your jack stand pads are too large (to fit without hitting the side trim) you may need a wood piece or better yet get the jack adapters for those ports
Seen some “jack pad” listings on amazon etc
Measure your (rectangular) jack port opening to make sure things fit etc
 

·
Registered
Joined
·
3 Posts
It has been over 6 months but maybe someone else will find this useful. Here are the lifting points mentioned by jmc above. Never mind Model 169.0 in the picture, it applies to Model 117 as well:

65245


Also you can get a special tool that fits into the slot:
65246


P/N for ordering:
65247
 

·
Registered
Joined
·
11,133 Posts
the aluminum ones i use are these ... from about 6 years ago

65248
 
1 - 5 of 5 Posts
Top