[jerry12345]

Hello, I am trying to remove my front bumper off my 2014 cla 250 to swap out the head light ballast. Im almost sure I removed all screws: 7 on top, 7 on the bottoms and 4 on each side. The top and bottom of the bumper is loose but the middle part is still stuck. Is there anything holding the middle part of the bumper?

 

[David170]

There are 1 "clip" on each side near the center of the grill, get a good grip and give in nice little pull.

 

[mcia13]

Hello, I am trying to remove my front bumper off my 2014 cla 250 to swap out the head light ballast. Im almost sure I removed all screws: 7 on top, 7 on the bottoms and 4 on each side. The top and bottom of the bumper is loose but the middle part is still stuck. Is there anything holding the middle part of the bumper?

The beginning of this document should help you on the bumper removal!

 

[jmc]

oh geee that file looks awfully familiar

 

[Matey]

Hi All,

Just piggybacking off the bumper removal. Is it best practice to disconnect the battery?

Just conscious that removing my front bumper and removing the sensor clips may throw up codes.

Any advice would be appreciated 😊

 

[ans]

Should be able to unclipped all the sensors from the bumper without disconnecting any of them from the car, well that's why did

 

[Matey]

Nice! Great thinking 🧐