Mercedes CLA Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello all !

I've just recently purchased a 2015 CLA250 4MATIC Sport and have just installed 12mm wheel spacers all round. I have also purchased H&R Lowering springs for the car but have just been stuck on whether to install them now since I've already scraped the front a few times going in to driveways etc... Do you think it would be a bad idea or do I go ahead and just angle the car as I'm going in to driveways? Has anybody lowered their CLA on H&R's? I'll attach and image of the car below. Thank you !
65924
 

· Premium Member
Joined
·
13,595 Posts
The longer front overhang is not very conducive to lowering .... -10mm maybe but most kits are -25mm+
Unless you go on pristine roads and shallow ramps be prepared for a lots of noise
I have been thinking about a scrape plate
 

· Registered
Joined
·
58 Posts
Hey which H&R springs/model # did you use for your 4matic? Last time I checked with H&R USA they do not make lowering springs for 4matic. They only made them for FWD
 
1 - 6 of 6 Posts
Top